Bespoke bendable light tracks, build your ideal outdoor luminous space
01
The Color Bridge cable bends by hand — around corners, along walls, across a pergola. No heat, no benders, no special tooling. Note there is a 300mm minimum bend radius.
Bends by Hand. No tools needed. Can be permanent or temporary.
02
Every fixture clips directly onto the wire — no exposed connections, no tools, and no glow from the cable itself. Want a different look tomorrow? Unclip it and move it by hand.
Clips to the wire. Tool-free. Easy to move.
03
Change the whole mood in a minute. Globe pendants for summer dinners, tight spotlights for winter. Same track, same driver — just a new fixture clipped where the old one was.
Modular. Reusable. Swap Easy.
Leaves Lighting Checklist
Good to know before you start.
No. Leaves runs on low-voltage DC24V and plugs into a standard outlet through its driver. If you can plug in a lamp, you can install it.
Yes. Every fixture and the track are rated IP65 — sealed against rain and dust — and built for year-round outdoor use.
Yes. The system carries 24 volts, not mains voltage, so the cable and fixtures are safe to handle, reshape, and be around.
Bend it with your hands. The silicone cable holds its shape; just keep curves above a 300mm radius so the run stays smooth.
Yes. The system supports low-voltage dimming from the driver, so every fixture dims together at a steady 3000K.
Unclip it and clip in a replacement by hand — no tools, no re-wiring. Fixtures are covered by warranty.
Clip them onto any free length of track, up to your driver's wattage. Need more power? Step up to the 72W driver or add a second run.
Outdoor-rated and warranty-backed — covering the track, fixtures, and drivers. Full terms are published with each product.
